The Six Shooter Pinhole Blender 4x5
4x5 film must be
loaded in total darkness
loaded in total darkness
Load
the film by attaching it to this tube with the emulsion side facing
outwards. Use the bands to hold the film on at the ends of the
tube. Position the film to the edge of the alignment notches that
are cut into each end of the tube. This notch aligns the film
so that the film edges face the seam on the can.
Back to Cameras Page.
Back to Cameras Page.
The winding system for the Blender 35 uses a reloadable film cassette as a take-up holder. This cassette is assembled with the spindle upside down.
First, cut the leader off your film and tape it to the take-up spindle with both spool ends facing up.
Slip cassette outer cover over spindle so that resulting assembly mirrors the supply roll.